Rotary Engraving Noses Part 3: The Different Types

Build on your understanding of how each type differs.

There are several different types of noses for rotary engravers:

  • Those with chip removal tubes – These noses are typically not interchangeable with the others. Older noses were made out of Teflon, but because of its cold forming problems, most manufacturers now use Delrin.
  • Drop-in and screw-on noses – Metal noses from SST are also common for times when the spindle exerts low pressure and/or some ghosting is not objectionable. These will work on most spindle micrometers.
  • Noses without vacuum removal tubes – On some applications, using a nose with no vacuum collection can be utilized. Usually, I utilize these when a surface is mare-resistant, a protected layer is applied, or can be finished afterwards.
  • Noses with vacuum removal – A chip removal system connects to a nose assembly tube to remove chips during engraving.
  • Tapered noses – For small lettering on contoured material. Mold work would fit this requirement. The end of the nose can be a small as 1/16″.
  • Bigfoot noses – These noses allow for engraving wide and/or multi-line text. The wider nose will not allow the depth change when larger areas are engraved.

Look back on Part 1: Challenges and Part 2: Advantages or consider these pieces of advice for rotary engravers.

Avatar of Julia Schroeder

Julia Schroeder

View all articles by Julia Schroeder  

Related Articles

Back to top button