How to Remove Engraving Residue from Wood

Charlie, GRAPHICS PRO Staff
epilog laser
If you’ve ever run your laser at low speed and high power, you’ve seen the results – sticky sap and varnish covering the areas you’ve already engraved. (Image courtesy Epilog Laser)

This method quickly cleans up all of that extra residue left on wood, leaving a clean, crisp engraving. Using a common and easily accessible hand soap, you can quickly and easily remove wood residue from any project. Additionally, the product we’re using for this project is a biodegradable, waterless, petroleum solvent-free hand cleaner that contains neither harsh chemicals, mineral oils, nor ammonia.

You need:

  • Permatex Fast Orange Hand Cleaner (available at any home improvement store)
  • Soft-bristle brush
  • Paper towels or cloth

Begin by placing a small amount of cleaner on the brush. Then, gently scrub the area until it is free of residue. When your project is residue free, simply wipe away any excess dirt and debris with a slightly damp paper towel.

Share this article

Authors

OUR DIGITAL PARTNERS

RELATED ARTICLES